Hi ​@flamerangerpnw -

It’s just an .exe installer. Go here:

https://www.veeam.com/kb4696

...and download the patch. Note: the .exe is only for patching the current 12.3.2.3617 version.

Then run it. I tend to reboot my server first, stop all Veeam services, then run the patch. If you’re VBR server is a VM..always good to take a snapshot first to make sure all goes well. That should be about it.

If you need to do an upgrade (from a version below “.3617”), follow:
https://helpcenter.veeam.com/docs/backup/vsphere/upgrade_vbr.html?ver=120

Best.

Download the ISO or EXE patch and run it.  That is it as it is simple this go round.

Hi ​@flamerangerpnw, kindly scroll to the end of this KB. You will find similar upgrade steps here.

Download Information
The installed build number can be found in the Veeam Backup & Replication Console's Main Menu (≡) under Help > About.
Patch for 12.3.2
This patch, available as an ISO or EXE, is intended ONLY for patching existing deployments of Veeam Backup & Replication 12.3.2 (build 12.3.2.3617).

All previous versions, including 12.3.0 and 12.3.1, must use the full ISO in the next section to upgrade.

After downloading the ISO, go to the file's properties, check the Unblock option, and click OK. Alternatively, unblock the file using this command:

Upgrading to 12.3.2.4165 From a Previous Version

Use the following ISO for:

• New deployments of Veeam Backup & Replication 12.3.2.4165.
• Upgrading existing deployments of Veeam Backup & Replication (11a, 12, 12.1, 12.2, 12.3.0, or 12.3.1) to 12.3.2.4165.

Remember to always review the Upgrade Checklist as part of your upgrade process.