+3In a previous post I’ve described how to enable the Kasten K10 Multi-Cluster Manager using the Helm. In this post, with the release of Kasten v7, I’ll describe the process of enabling the Multi-Cluster Manager using the Kasten UI, which as you will see, it’s quite easy!!!
+21Great post Patricio. After VeeamON going to finally start learning Kasten. 😜
+3great post. I take the chance to pose a question: I have to help a customer in setting up the multi cluster tool in an environment where we are finishing installing the K10 instances on 6 OSCP clusters in Operator mode. The version installed by operator is 6.5.4
Official doc is here https://docs.kasten.io/6.5.4/multicluster/tutorials/getting_started.html#
and I was searching for a post like the one from Patricio, but for operator based installs.
+21great post. I take the chance to pose a question: I have to help a customer in setting up the multi cluster tool in an environment where we are finishing installing the K10 instances on 6 OSCP clusters in Operator mode. The version installed by operator is 6.5.4
Official doc is here https://docs.kasten.io/6.5.4/multicluster/tutorials/getting_started.html#
and I was searching for a post like the one from Patricio, but for operator based installs.
If you have a question you are better off to post in the Kasten K10 thread here - Kasten K10 Support | Veeam Community Resource Hub
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
